Diy barn door hardware – Monte track; with an assistant, level and mark the wall mounting track at the correct height. Check both ends of the runway for ground clearance and use the shorter side. The track must be level (so that the door does not roll) and not necessarily parallel to the ground. Drill the family places for a fourth “pilot hole.
Loosely bolt the track to the wall. Drill three mounting holes through holes drilled track at the top of the door. Since the holes are 1 / 2 “with a 5/16” I tirafondo (3 to 4 “long), the level of the track diy barn door hardware before tightening firmly. If the track is not level, the door can roll to one side or the other on their own. Place a half” wooden wedge on the ground at the highest point.
Place the door of the wedge and, with an assistant, put the wheels on the track, pointing to the right end bolts fastening strap on the door places. Drill two holes in each strap (8 in total) for 1/2 “to 05/16” bolts. Remove the wooden wedge the door and check for proper roll. Each pin can be loosened to move the track in and out of the wall or the door up and down on the straps. Install door stops required on the wall or on the floor if you do not put them in the top track. Yeach, that’s about Monte track diy barn door hardware.acresd5y, diy barn door hardware