Plug In Wall Sconces – Installing a wall light is one of the most common DIY tasks. The operation is within the reach of all, provided to have at the wall outlet of a power supply already connected to the control switch. Phase (red, brown, orange …), power from the switch (single ignition) or push buttons (back and forth). Neutral (blue), connected to the branch circuit breaker without going through the controls.
Earth (yellow / green striped), connected to the board distribution board. Before screwing in the bottom, pull out the power wires again. Place the bottom of the wall, matching its screw holes with the anchors. Check the position on the spirit level. Screw it firmly. Strip the end of the wires 6 to 8 mm. Thread on the small protective tubes provided with the bracket and tighten them in the plug in wall sconces terminals of the terminal strip. Each terminal is marked with the letter or symbol corresponding to the wire intended for it.
Good to know: The letter L is the English sign (for Line) indicating the phase. The DCL boxes are equipped with a cover incorporating a fingerprint intended for a specific, snap-on plug. The wires are plug in wall sconces into a terminal strip on the back of the cover. The plug is equipped with a socket in which the bulb is screwed. As soon as it is inserted into the housing cover, the bulb is ready for operation.
Plug in wall sconce target,